Configuration

May 13, 2013 at 3:40 AM
Edited May 13, 2013 at 4:04 AM
Hi

Nice solution - but struggling a bit... so is there a config guide available ?

Got a list with names, address and 2 separate columns; lat + long - if I enter some digits in these it's not working..

whats the format of the lat and long column ? - tried with the:

40°26′47″N
40° 26.7717
40.446195N
40.446195

but can't get it working...
Jan 24, 2014 at 2:41 PM
Edited Jan 24, 2014 at 2:50 PM
I'm having the same issue with similar setup

Running SharePoint 2010 Foundation

As a test I created a simple list with one row - Title, Latitude, Longitude

Started with a blank page, added a listview webpart showing my list, then the map webpart

Connected with 'Get table from'.. set the map webpart to Webpart Connection mode, set the Latitude and Longitude column name

And the map doesn't show any points, just stays at the initial World Level zoom

If I put my longitude/latitude values in as the Centre locations, it will properly center the map.. but otherwise I can't get anything working for showing points from a connected list

http://imgur.com/kJ2dEUX
Jan 24, 2014 at 3:10 PM
Ok seem to have it working now

Turns out that the Title column name MUST be entered, maybe should be added to the documentation?
Coordinator
Jan 25, 2014 at 9:59 PM
Edited Jan 25, 2014 at 10:02 PM
Hi,

Title column is not mandatory anymore. Check the last release.
Jan 27, 2014 at 1:25 PM
Excellent, thanks for all the hard work!